Its that old film on new installed glass of many kinds that sit for too long and then takes for ever to take off. One your scraping it off and scratching th Make sure the heat gun isn’t in one spot for too long—you don’t want the vinyl to bubble or start to burn. the heat needed to remove the vinyl will depend on the vinyl manufacturer. Peel a corner or edge of the material and slowly pull at a 45-degree angle. This ensures that the vinyl doesn’t tear or break apart.

Patiently let it sit for 1 minute. 7. Using a fresh, clean scraper, slowly and carefully scrape the adhesive surface to remove a layer of adhesive. This may require slightly more pressure then removing the film, but not a lot more. Don't bother attempting to dig under the adhesive, rather just shave the surface off.

Step 3: Peel off the film from the window. After removing the tint, peeling off the film will take less time. The sheet becomes weak and comes off nicely. To remove the film, use a razor blade and strip the sheets from the corners. Apply heat using a blow dryer with one hand and with the other handset an angle to peel the film with a sharp

Our new stainless steel fridge-freezer was moved into the sun by the builders whilst building us a new kitchen. Due to delays in the getting the worktop from Australia (don't ask), the fridge was in the sun (empty, not being used) for almost 3 months. This fused the "protective" film to the brushed stainless surface.

. 428 191 9 274 149 207 94 203

how to remove old protective film